04-19-2011, 05:20 PM
|
#1
|
Turbo Member
Join Date: Feb 2011
Location: Virginia/Philippines
Name: PI_greg
Posts: 1,370
|
LT install status
Ok, here's the status. I got a set of LT Pacesetter's used and finally cleaned-up the collectors as the pipes on the previous truck were just cut off. Something I noticed while I was removing the pieces of old pipe and the welds is the ceramic needs to ground off to make a good weld. Tapped the O2 bung holes. Got my OEM exhuast bolts all cut to proper lenght, OEM gaskets. Pacesetter 3" Y pipe. I'll take the cats (OEM 03 cats) to the machine shop tomorrow and cut the ends off of them to remove the choke points on either ends. I got a lift lined up this weekend and a helper. So this looks like I'm finally ready for the header install. OBTW, Red is running great and I am excited by what the headers might do. Springs and cam next week if all goes well. As a side note, if this all goes well and I don't get caught up trying to sort shit out, I'm going to drop her another inch all around. wish me luck...
Edit: I am following Ryans lead as he has a really good LT install and provided a ton of pictures. Thanks Ryan.
|
__________________
PI_greg 2003 SXT-Hemi, SS/T rims, 275/60-17, AeroForce, w/wideband, 6.1 ignition, K&N-77 CAI, Fastman TB, eFan, 180 stat, TMR, HD OEM Trans Cooler, SC3865/PSC1, Dual window switch/ high idle mod, Edge, Crazy Spartan (112 lsa), 2800, DTT 4:10, TCI Floor Shifter, Shift lite, Pacesetter Ceramic LT's, Magna Spun Cats/SI/DO Muffler, Mcgaughys 2/4.5 spindle kit, Monroe shocks, Caltracs, Aeon springs bumps, SRT-10 gage pillar, air horn
Last edited by Redtruck-VA; 04-19-2011 at 05:38 PM.
|
|
|