Semopar Forum

**4XLGator** · 12-26-2010, 01:06 AM

What's up people? I guess the thread I started in another section should've went here.

Here's a couple pics...

**SmokedRam** · 12-26-2010, 01:13 AM

Those flares give that truck personality man....looks good...

**Onk** · 12-26-2010, 01:16 AM

After seeing your truck, I am seriously considering getting some fender flares....they look BADASS!!!

What brand are those you have and how much abouts do they go for???

**SmokedRam** · 12-26-2010, 01:19 AM

look like Bushwacker Pocket Flares

Stealth Mode · 12-26-2010, 01:33 AM

Loving the truck man!

I alway's wanted one, triple matte black on Rockstar 22's dropped and leveled about 4". Make it look stout.

**4XLGator** · 12-26-2010, 01:33 AM

^^^ Correct, they are Bushwhacker pocket-style flares.

They run around $450 - $475 but you can catch them on sell. I bought mine from Amazon at $360 and free shipping. I had them painted for only $100, but that was by a family member's friend. One place wanted $350 to paint them, which I thought was crazy.

**Onk** · 12-26-2010, 01:35 AM

hard to install???

**SmokedRam** · 12-26-2010, 01:36 AM

$384 a set, plus free shipping PLUS 15% off...(til the 27th)

http://www.autoanything.com/fender-f...spx?kc=ffskupo

**4XLGator** · 12-26-2010, 01:41 AM

Originally Posted by RamStrat

hard to install???

The front ones literally took about 5 minutes...just remove the 3 factory 8mm screws, hold the flare in place and reinsert and tighten 8mm screws.

The back ones take longer but that is because there are only 2 factory 8mm screws in the front of the rear fender. Then, at the rear of the fender there are two factory holes that you slide clips (supplied with flares) over and screw in. Also included are 3 s-clips and screws in between those mounting locations.

What takes the longest is prep work, which includes:
1) putting on rubber trim (can't see in pic but it goes between flare and truck)
2) drilling holes and installing all the stainless bolts, washers and ny-lok nuts; but there are indents where u drill so the drill bit doesn't walk.

The stainless torx head bolts you see are just for looks. All hardware, rubber trim and even T45 torx bit is included with the flares.

**4XLGator** · 12-26-2010, 01:44 AM

Originally Posted by 96MagnumRam

$384 a set, plus free shipping PLUS 15% off...(til the 27th)

http://www.autoanything.com/fender-f...spx?kc=ffskupo

Bushwhacker is excluded in the 15% off (friggin fine print sucks!), but a good deal nonetheless.